Any waterproofing system is only as
good as its weakest point. With over 30 years in the deck
waterproofing industry, DEC-K-INGknows from experience where water
is most likely to infiltrate the building envelope. V-Kote Tek™ is engineered to add protection to the
most critical areas of a project, offering PVC
coated accessories and pre manufactured solutions to
ensure factory consistency throughout. Reinforced PVC
membrane details previously impossible to make, extending in multiple
directions, are now manufactured by sophisticated electronic
equipment. V-Kote Tek™ is the most technologically advanced
deck waterproofing system on the market. Click on the pictures below
for close-ups.
V-Kote Tek™- The Ultimate Deck
Waterproofing System
Corners: Every corner is sealed
100% and is consistent throughout the project.
PVC Coated
Metal Flashing: Membrane is
heat welded permanently to top of PVC coated flashing rather than
bent over flashing which only adds stress to the
membrane.
Termination: Wall/deck
transition piece protects structure from water returning off
the drip flashing.
Scuppers & Overflows:
Spun aluminum, PVC coated unit; deck
membrane heat welded to flange. A special skirt is also welded to
outside wall. Seals permanently inside and outside of
structure.
Drains:
One- piece metal drain is PVC coated.
Membrane is permanently heat welded to drain. No glue. No
caulking.
Post Boot:
The entire post is wrapped in one
piece with the overlap heat welded to the PVC
membrane.
Door Corner Boot:
Protects the critical area with a one-piece
factory made unit.
Downspout Boot: One-piece, factory made downspout boot seals
the entire unit.
Railing Boot:
Keeps water away from the base and
fasteners.
Boot is heat welded
permanently to the deck membrane.
Railings on
Parapet Walls: Railing base plate is chemically bonded to a
60-mil PVC membrane and fused to the PVC coated flashing. Railing
base plate is also sealed to the PVC membrane with a PVC
rod.
Scuppers & Overflows: 
